My stihl 026 runs fine until its under a load "cutting wood" and it wants to die,I changed the plug ?
Aug 17, 2008 by cannondale | Posted in Maintenance & Repairs
the saw will start sheer and idle fine untill it gets into cutting wood then it wants to die.
It has a new confine on, the oiler is working fine, turned up the jets and turned down still does the same factor.
One of 3 things, the encourage line is sucking air, the boot or impulse hose between the carb and cylinder is leaking, or the crankcase seals are universal bad. My bet would be on the boot or impulse hose. Hoad the same thing come to pass to a saw that came in here today, and
Todd B | Aug 19, 2008
Can you help me adjust the carb on my 026 Stihl chainsaw?
Dec 03, 2008 by Lou | Posted in Garden & Landscape
Beside the low and strident speed adjustment is an arrow that goes 1 turn table clockwise. I tried turning both screws 1 turn piece clockwise like the arrow suggests and it will run fine for a few minutes. It sounds good when I rev it up but when I stop it shuts off. Is there
Start it up.
Then with it contemporary turn the low speed jet until it starts to stall. Then turn the jet the facing way until it starts to stall. Then put it in between the two stall points.
Then adjust the serious speed jet. It's a little harder to do.
Carl | Dec 03, 2008
